Zanussi Range ZVT65X User Manual

GB  
User manual  
2
Ceramic glass hob  
ZVT65X  
 
• Product number (Prod. Nr.) ............. ....  
Seal the appliance to the work top with no space left with  
a correct sealant!  
Protect the bottom of the appliance from steam and  
moisture, e.g. from a dishwasher or oven!  
Do not install the appliance adjacent to doors and below  
windows! If not, hot cookware can be hit off the hob when  
you open doors or windows.  
• Serial number (Ser. Nr.) ...............  
You find the rating plate of the appliance on its lower  
casing.  
ZVT65X  
949 593 019 01  
6,4 kW  
220-240 V 50-60-Hz  
58HAD03AO  
ZANNUSSI  
Warning! Risk of injury from electrical current.  
Carefully obey the instructions for electrical  
connections.  
Safety instructions  
Warning! You must read these!  
• The electrical mains terminal is live.  
• Make electrical mains terminal free of voltage.  
• Install correctly to give anti-shock protection.  
• Loose and incorrect plug and socket connections can  
make the terminal become too hot.  
• A qualified electrician must install the clamping con-  
nections correctly.  
Make sure that the appliance is not damaged  
because of transportation. Do not connect a damaged  
appliance. If it is necessary, speak to the supplier.  
Only an authorised service technician can install, connect  
or repair this appliance. Use only original spare parts.  
Only use built-in appliances after you assemble the  
applianceintocorrectbuilt-in unitsandworksurfacesthat  
align to the standards.  
Do not change the specifications or modify this product.  
Risk of injury and damage to the appliance.  
Fully obey the laws, ordinances, directives and standards  
in force in the country where you use the appliance (safety  
regulations, recycling regulations, electrical safety rules  
etc.)!  
Keep the minimum distances to other appliances and  
units!  
Install anti-shock protection, for example install the  
drawers only with a protective floor directly below the  
appliance!  
Protect the cut surfaces of the worktop against moisture  
with a correct sealant!  
• Use a strain relief clamp on cable.  
• Use the correct mains cable of type H05BB-F Tmax  
90°C (or higher) for a single-phase or two-phase con-  
nection.  
• Replace the damaged mains cable with a special cable  
(type H05BB-F Tmax 90°C; or higher). Speak your lo-  
cal Service Force Centre.  
The appliance must have the electrical installation which  
lets you disconnect the appliance from the mains at all  
poles with a contact opening width of minimum 3 mm.  
You must have correct isolation devices: line protecting  
cut-outs, fuses (screw type fuses removed from the hold-  
er), earth leakage trips and contactors.  
3
 
Assembly  
600 mm  
min. 500mm  
min.  
50 mm  
560+1 mm  
490+1 mm  
R5  
min.  
25 mm  
min.  
20 mm  
min.  
30 mm  
4
 
Description of the appliance  
Cooking surface layout  
1
2
1
2
3
4
5
Single cooking zone 1200 W  
Single cooking zone 1800 W  
Single cooking zone 1200 W  
Control panel  
3
Double cooking zone 750/2200 W  
5
4
Control panel layout  
1
2
3
4
Use the sensor fields to operate the appliance.  
sensor field  
function  
1
2
3
4
starts and stops the hob  
starts and stops the outer ring  
with indicator  
heat setting display  
shows the heat setting or functions which are on  
increases or decreases the heat settings  
/
Heat setting displays  
Displays and sounds tell which functions are started  
Display  
Description  
The cooking zone is off  
5
 
Display  
Description  
The cooking zone operates  
There is a malfunction  
-
A cooking zone is still hot (residual heat)  
Lock/Child safety device is on  
The automatic switch off is active  
Residual heat indicator  
Warning!  
Risk of burns from residual heat!  
Operating the appliance  
• you cover a sensor field with an object (a pan, a cloth,  
On and Off  
etc.) for longer than 10 seconds. The sound operates  
some time and the hob stops. Remove the object or  
clean the control panel.  
Touch  
for 1 second to start or stop the appliance.  
Automatic Switch Off  
The function stops the hob automatically if:  
• you do not stop a cooking zone or change the heat  
setting after some time. See the table.  
comes on.  
all cooking zones are off  
.
• you do not set the heat setting after you start the hob.  
Automatic Switch Off times  
Heat setting  
-
-
-
Stops after  
6 hours  
5 hours  
4 hours  
1.5 hours  
The heat setting  
Touch  
of the two front cooking zones at the same  
time for 4 seconds. The symbol  
off the appliance.  
comes on. Switch  
Touch  
creasetheheatsetting. Thedisplayshowstheheatsetting.  
Touch and at the same time to switch off.  
to increase the heat setting. Touch  
to de-  
Switching off the child safety device  
Start the hob with  
. Do not set the heat settings .  
Switching the outer ring on and off  
You can match the effective heating surface to the size of  
the cookware.  
To switch on the outer ring touch the sensor field  
The indicator comes on.  
To switch off the outer ring touch the sensor field  
again. The indicator goes out.  
Touch  
of the two front cooking zones at the same  
time for 4 seconds. The symbol comes on. Switch  
off the appliance.  
.
Overriding the child safety device for one cooking session  
Start the hob with  
. The symbol  
comes on.  
Touch of the two front cooking zones at the same  
time for 4 seconds. The symbol comes on. Set the  
heat setting in less than 10 seconds. You can operate  
The child safety device  
This function prevents an accidental operation of the hob.  
the hob. When you stop the hob with  
safety device operates again.  
, the child  
Starting the child safety device  
6
Start the hob with  
. Do not set the heat settings .  
 
Helpful hints and tips  
Cookware  
• Stop the cooking zones before the end of the cooking  
time to use residual heat.  
• The bottom of pans and cooking zones must have the  
same dimension.  
• The bottom of the cookware must be as thick and  
flat as possible.  
• Cookwaremadeofenamelledsteelandwithaluminium  
or copper bottoms can cause discoloration on glass  
ceramic surface.  
Examples of cooking applications  
The data in the table is for guidance only.  
Energy saving  
• If possible, always put the lids on the cookware.  
• Put cookware on a cooking zone before you start  
it.  
Heat  
Use to:  
Time  
Hints  
setting  
1
Keep cooked foods warm  
as re-  
quired  
Cover  
1-2  
Hollandaise sauce, melt: butter, chocolate, ge- 5-25 min Mix occasionally  
latine  
1-2  
2-3  
3-4  
4-5  
4-5  
6-7  
Solidify: fluffy omelettes, baked eggs  
10-40  
min  
Cook with a lid on  
Simmer rice and milkbased dishes, heating up 25-50  
ready-cooked meals  
Add at least twice as much liquid as rice,  
stir milk dishes part way through  
min  
Steam vegetables, fish, meat  
20-45  
min  
Add a few tablespoons of liquid  
Use max. ¼ l water for 750 g of potatoes  
Up to 3 l liquid plus ingredients  
Turn halfway through  
Steam potatoes  
20-60  
min  
Cook larger quantities of food, stews and soups 60-150  
min  
Gentle fry: escalope, veal cordon bleu, cutlets, as re-  
rissoles, sausages, liver, roux, eggs, pancakes, quired  
doughnuts  
7-8  
9
Heavy fry, hash browns, loin steaks, steaks  
5-15 min Turn halfway through  
Boil large quantities of water, cook pasta, sear meat (goulash, pot roast), deep fry chips  
Information on acrylamides  
starch), acrylamides can pose a health risk. Thus, we  
recommend that you cook at the lowest temperatures and  
do not brown food too much.  
Important! According to the newest scientific knowledge,  
if you brown food (specially the one which contains  
Care and cleaning  
Clean the appliance after each use.  
Always use cookware with clean bottom.  
7
 
ceramic scraper. Put the scraper on the glass ce-  
ramic surface at an acute angle and slide the blade  
on the surface.  
Stop the appliance and let it cool down before you  
clean: limescale rings, water rings, fat stains, shi-  
ny metallic discolorations. Use a special cleaner  
for glass ceramic or stainless steel.  
Warning! Sharp objects and abrasive cleaning  
agents will damage the appliance.  
For your safety, do not clean the appliance with steam  
blasters or high-pressure cleaners.  
Scratches or dark stains on the glass ceramic have  
no effect on how the appliance operates.  
Removing the dirt:  
1. – Remove immediately: melting plastic, plastic foil,  
and food containing sugar. Use a special glass  
2. Clean the appliance with a damp cloth and some de-  
tergent.  
3. At the end rub the appliance dry with a clean cloth.  
What to do if...  
Problem  
Possible cause and remedy  
You cannot start the appliance or op- • You touched 2 or more sensor fields at the same time. Only touch one  
erate it.  
sensor field.  
• There is water or fat stains on the control panel. Clean the control panel  
The child safety device operates  
“Child safety device”.  
. Stop the function. See the section  
• Start the appliance again and set the heat setting in 10 seconds.  
The residual heat indicator does not The cooking zone is not hot because it operated only for a short time. If the  
come on.  
cooking zone must be hot, speak to the after sales service.  
A sound operates and appliance starts  
and stops again. After 5 seconds one  
more sound operates.  
You covered  
. Uncover the sensor field.  
• The automatic switch-off operates. Stop the appliance and start it again.  
Overheating protection for the cooking zone operates. Stop the cooking zone  
and start it again.  
comes on.  
There is an error in the appliance.  
and a number come on.  
Disconnect the appliance from the electrical supply for some time. Discon-  
nect the fuse from the electrical system of the house. Connect again. If  
comes on again, speak to the after sales service.  
If you tried the above solutions and cannot repair the  
If you operated the appliance incorrectly, the servicing by  
problem, speak to your dealer or the Customer Care De- a customer service technician or dealer will not be free of  
partment. Give the data from the rating plate, three-digit- charge, even during the warranty period. The instructions  
letter code for the glass ceramic (it is in the corner of the about the customer service and conditions of guarantee  
cooking surface) and an error message that comes on.  
are in the guarantee booklet.  
Environment concerns  
and electronic equipment. By ensuring this product is  
disposed of correctly, you will help prevent potential  
negative consequences for the environment and human  
health, which could otherwise be caused by inappropriate  
The symbol  
on the product or on its packaging  
indicates that this product may not be treated as  
household waste. Instead it should be taken to the  
appropriate collection point for the recycling of electrical  
8
 
nents are identified by marking: >PE<,>PS<, etc. Discard  
the packaging materials as household waste at the waste  
disposal facilities in your municipality.  
waste handling of this product. For more detailed  
information about recycling of this product, please  
contactyourlocalcouncil, yourhouseholdwastedisposal  
service or the shop where you purchased the product.  
Packaging material  
The packaging materials are friendly to the envi-  
ronment and can be recycled. The plastic compo-  
9
 
10  
 
11  
 

Weed Eater Trimmer 31WG User Manual
Weider Fitness Equipment 8311591 User Manual
Weider Home Gym WESY59531 User Manual
Whirlpool Cooktop GJC3034H User Manual
Whirlpool Washer Dryer W10198562A User Manual
White Rodgers Home Security System F145RF 1600 User Manual
Yamaha DVR CBX D5 User Manual
Zanussi Oven 238500 User Manual
Zanussi Refrigerator 110048 User Manual
Zanussi Washer Dryer ZWD 1252 W User Manual