Whirlpool Microwave Oven DP 009 User Manual

DP-009  
September 2006  
8178602  
Delivery & Installation Pointer  
September 2006  
Exhaust Blower Change  
New Microwave Hood Combination  
(MHC)  
(Whirlpool Brand)  
ISSUE:  
The newly designed MHC is shipped with the exhaust blower in the recirculation  
position.The blower can be rotated for a top discharge or rear discharge by removing  
the 2 recessed screws on the rear of the MHC. The 2 visible gold colored screws  
under the blower housing are being removed in error.  
BACKGROUND:  
Procedure to reverse the blower assembly.  
1. Locate the 2 screws that loosen the blower assembly. The screws are located in  
the holes below the blower assembly (See Figure A.)  
RECESSED SCREWS  
DO NOT REMOVE  
THESE SCREWS  
FIGURE A  
2. Removing the 2 screws will require either a hand screwdriver or a longer phillips  
bit for your drill. These screws are recessed into the hole approximately ¾”.  
3. Remove the blower assembly and rotate to the desired position.When rotating the  
blower it is best to disconnect the wiring harness plug before rotating the blower  
assembly. After repositioning the blower reinstall the wiring harness plug.  
4. Do not to overtighten the 2 blower screws when reinstalling.  
 

Weed Eater Trimmer 530086725 User Manual
Western Digital Computer Drive WD1600BJKT User Manual
Western Digital Computer Drive WD RE3 User Manual
Whirlpool Dishwasher ADG 9500 User Manual
Whirlpool Dishwasher W10682797A User Manual
Wolf Range C36B 6 User Manual
X10 Wireless Technology Universal Remote IR32A User Manual
Yamaha Automobile FJR13AXC User Manual
Zanussi Range ZGF 782 User Manual
Zanussi Refrigerator 102028 User Manual